Ghost Trap Fog Pump Kit

This is a Fog Pump Kit for my 3D printed Ghost Trap for which you can download files here:
http://bit.ly/Ghost_Trap_3D_Files

These are only the parts shown in first picture for a Fog Pump Kit – you must supply your own fog source, electronics interface and additional 3D printed parts!

See the assembly guide for more info & fog source suggestions here:
http://bit.ly/3D_Kit_Instructions

KIT INCLUDES:
– 6V Vacuum Pump – can be run from 5V – 6V DC
– Transistor – necessary for controlling from an Arduino, etc
– Rubber Pad – for clamping into motor mount (which you must 3D print)
– Tubing Set – tubing to run from fog from outlet on top of trap. tubing fits diameters from 1/4″ – 3/8″
– Tubing Connectors
– Fluid Bottle – for fluid of your choice. Needle applicator makes refilling easier.

All the parts needed to make a fully functional Ghost Trap from my 3D files are as follows:
– Adafruit Industries parts: http://www.adafruit.com/wishlists/457074
– Door Mech Kit: http://etsy.me/2CtIV8L
– Misc Electronics Kit: https://www.etsy.com/listing/580803474
– Electro-Mechanics Guide: https://www.etsy.com/listing/594659119
– And finally this kit listing which consists of the fog pump parts

See the fog in action here:
http://bit.ly/Ghost_Trap_Demo