Korbanth MW1 JimmysSaberJunk Lightsaber Chassis

Removable chassis for the Korbanth MW1 hilts.

Also available from the JimmysSaberJunk Shapeways store for super professional prints.
https://www.shapeways.com/shops/jimmy-s-lightsaber-junk?section=Korbanth+MW1&s=0

This is a removable battery design.
The battery terminals that are required for this chassis design are included with your purchase

This chassis is designed for use with:
-ProffieBoard, GHV3 or Verso (select from drop down menu – board not included)
-KR Sabers 24mm Bass speaker (not included)
-18650 Lithium Ion Battery (not included)
-High amp kill switch (not included)
—- Purchase Here: https://www.etsy.com/listing/885094580/on-off-slide-switch
-Two 6 x 6 x 4.3mm tactile switches (included)
-Two single RGB pixels for the accent lights (included)
-Shtok Short Pin Hilt side LED PCB (not included-most likely requires sanding down on the outside diameter)

Thread the printed alignment parts in the correct orientation in the emitter of the hilt, so the chassis will line up correctly each time you insert the chassis.
This design allows for the board to slide into place once wired up and tested.
After wires are soldered to the battery tabs, I suggest carefully heating up the battery tabs to insert them in to the chassis. This not only makes it a lot easier to insert them, but also forms the plastic around them, holding them far better.

This is printed using PLA plastic. Handle with care.
Any damage occurred during installation is the responsibility of the individual installer.