One Replicas SSLk JimmysSaberJunk Lightsaber Chassis

Chassis for the One Replicas SSLk hilts.

This is a permanent wired in battery design, not removable.

Also available from JimmysSaberJunk Shapeways store for super professional prints.
https://www.shapeways.com/shops/jimmy-s-lightsaber-junk?section=OneReplicas+SSLk&s=0

This chassis is designed for use with:
-Proffie Board, GHV3 or Verso (options available via drop down menu – boards not included)
-28mm Bass speaker (not included)
—- Purchase Here: https://www.etsy.com/listing/834078758/sw-28mm-bass-speaker-2w-4ohm
-18650 Lithium Ion Battery (not included)
-2.1mm recharge port (included)

One chassis per purchase. This design allows for the board to slide into place once wired up and tested.
The recharge port requires gluing in to place once everything is wired up and tested. We recommend a dab of hot glue to secure it. You can secure the battery into the chassis with a dab of hot glue too.
When wiring up to the hilt, I recommend letting the wires to the switches and emitter to have some slack, enough for you to pull the chassis out far enough to access the board after you have undone the retention screw.

Any damage occurred during installation is the responsibility of the individual installer.